So what i have for a amp is an MPS 2500 and what i was woundering is what amp should i match up with the MPS?? the 2500 will run the front and what to use for the back will be running 4-10" or 4-12" sub's????
MS2250 MS1000 or ????
Build Question
-
mhyde71
- Dr. Jekyll
- Posts: 6231
- Joined: Sun Jan 20, 2008 8:34 pm
- Location: PG FanBoy in Green Mtn Vermont
- Contact:
i bet it's a Blue FJ Cruiser ... I could be wrong tho- just taking a guess.
BUT yeah What he said ^^^^
4-subs' sounds like maybe a job for a MS1K
think kinda need to know more info tho- i.e. SVC/DVC, Watts desired by what for what?? stuff like that5...
Do you have a MS1K?
BUT yeah What he said ^^^^
4-subs' sounds like maybe a job for a MS1K
think kinda need to know more info tho- i.e. SVC/DVC, Watts desired by what for what?? stuff like that5...
Do you have a MS1K?
PAST WORK/S HERE::
https://www.facebook.com/KhameleonKoatings/photos_albums
https://www.facebook.com/KhameleonKoatings/photos_albums
Use the MPS2500 on the subs. You want 4 subs... get some SVC 4 ohms (or DVC 2 ohms wired in series) and wire them all in parallel for a 1 ohm final load. The 2500 would produce a solid 750 or so watts at that level.
Then you can get something like an MS275 or MS2125 to run your front stage. Much better suited for the higher impedance of component speakers.
Then you can get something like an MS275 or MS2125 to run your front stage. Much better suited for the higher impedance of component speakers.