Bridging an MS2125

vin78 · Post by **vin78** » Mon Mar 23, 2009 6:54 am

As the manual states - you must flip the switch to "bridge" and use the left speaker output. However, I was playing around with the switch the other day and and switched it to stereo and there was no difference

Is there another way that I dont know about to bridge the amp?

shaheen · Post by **shaheen** » Mon Mar 23, 2009 6:57 am

Using the switch allows the amp to be used in a single mono set up , with one INPUT, the bridge is actually on the OUTPUT side with L+ve and Right -Ve .

When using the switch it allows both inputs to be used, but will mono the signal.

vin78 · Post by **vin78** » Mon Mar 23, 2009 7:48 am

Thanks for the insight. But to run the amp mono, which speaker output do I use? Just the left channel? Or use + for left ch and - from right ch, like most amps?

Post by **joerg** » Mon Mar 23, 2009 7:52 am

If u have the original metal bottom just take a look at it!

shaheen · Post by **shaheen** » Mon Mar 23, 2009 9:30 am

shaheen wrote: the bridge is actually on the OUTPUT side with L+ve and Right -Ve .

As posted

vin78 · Post by **vin78** » Mon Mar 23, 2009 9:38 am

Oh I see, thanks
reading > Me sometimes

:D:D