Page 1 of 1
Can I use a fuse distribution box in place of an Inline ANL
Posted: Wed Mar 21, 2007 11:21 am
by Capital_M
The only Knukoncepts distribution block that can take 1/0 gauge input/output is also a fuse block. But its not water proof.
Or should I use both an ANL and a Fuse Distribution block
Posted: Wed Mar 21, 2007 11:43 am
by AVICJR
Use both, the inline fuse goes as close to your battery as possible, and the dist. block should be close to where you mount your amps.
Posted: Wed Mar 21, 2007 12:35 pm
by 1moreamp
I have a TIBBKF-3? that goes 1/0 in and 2 1/0 out but that pretty much what your asking about right?
And no they are not water proof at all, but its real pretty in that Ti finish with those pretty indicator lights inside. Its almost worth mounting in a plexi housing under the hood < I got a guy that does custom plexi affordable>
Posted: Wed Mar 21, 2007 12:52 pm
by Capital_M
1moreamp wrote:I have a TIBBKF-3? that goes 1/0 in and 2 1/0 out but that pretty much what your asking about right?
And no they are not water proof at all, but its real pretty in that Ti finish with those pretty indicator lights inside. Its almost worth mounting in a plexi housing under the hood < I got a guy that does custom plexi affordable>
fuckin niiiiiiice
Posted: Wed Mar 21, 2007 12:57 pm
by 1moreamp
Yeah I think so too, they are getting real hard to find also, from what I am told> I have already had three offers for it.
Posted: Wed Mar 21, 2007 12:59 pm
by Capital_M
If I was doing a real nice show off install I'd probobly look into one, but for now knukoncepts will do just fine
