Page 1 of 1
ZPG 100 or ZRT 100 ??
Posted: Wed Mar 21, 2007 3:42 pm
by AVICJR
I have always used the set screw type tightening terminals. I just got these and am having trouble getting them to compress and hold on to the wire. I stripped away exactly the perfect amount of wire to fit inside the hole in the ground terminal and it's not holding after I tighten. Is there a trick or am I just doing it wrong?
Posted: Wed Mar 21, 2007 3:47 pm
by Bfowler
if are you talking about the 2 peice kind that screw back on from behind the terminal, you have to strip the wire PAST the gold end piece and bend the wire back over the outside of the fitment, THEN screw it on
Posted: Wed Mar 21, 2007 3:51 pm
by AVICJR
Thank you. I didn't realize I had to bend it back around. Jeez I feel stupid.
Posted: Wed Mar 21, 2007 4:23 pm
by dedlyjedly
lol. yep, the hdx style termination is one of the best, but it's not magic! leave about 1/3" protruding thru the gold ring and then fold it back over. just make sure the strands aren't too long or they'll interfere with the threading on the insert.
Posted: Wed Mar 21, 2007 4:35 pm
by Bfowler
dont. i did the same damn thing my fist time. in fact it was probibly worse becasue the cable i used was think enough to hold the fitment on, so i didnt notice it wasnt a good conection until it fell out while we were testing the amp