Page 1 of 1
RSD 6.5" dimensions
Posted: Sun May 31, 2009 6:46 am
by Audiophiliac
Can someone with a RSD 6.5" measure it to find out 2 things:
1. Overall diameter
2. Mounting diameter (distance between the mounting holes....mine uses 4 holes 90 degrees from each other)
I know 2 speaker that I have used fit perfectly with no mods to my doors. Exile XT65 and ID CX62. I am thinking of trying the RSDs if they will fit good.
Thanks!
Posted: Sun May 31, 2009 8:08 am
by waynehead
I am all about trying them too. I just ordered a pair yesterday and dont even have anything to put them in. I dont understand replacing the the cx62's tho.
Posted: Sun May 31, 2009 9:41 am
by Audiophiliac
I am not replacing anything. I have none speakers at the moment. I had CX62s in my old GTI. Then I upgraded to the XT65s. And yes...it was an upgrade. They sounded better.
I want to just order another set of those and call it good. But I thought I would try some PG stuff.
I had Xenons before and liked them...but they lacked anything below 150Hz or so.
Posted: Wed Jun 03, 2009 9:16 pm
by Audiophiliac
bump. someone measure
Posted: Thu Jun 04, 2009 9:18 am
by Bfowler
i can hook that up for you later today mang.
Posted: Thu Jun 04, 2009 4:31 pm
by Audiophiliac
Its later!
Posted: Fri Jun 05, 2009 11:17 am
by smgreen20
5 11/16" over all outside dia. 5 7/16" from center of mount hole to center of mount hole Diagonally.
4 mount holes at 90 degrees.
Posted: Fri Jun 05, 2009 4:22 pm
by Audiophiliac
Bummer....too small. Back to Xtecs or ID CXS v2. Seems like they fixed the problems with dust getting in the gap...that is why I sold my old CXS62.
Posted: Fri Jun 05, 2009 6:13 pm
by smgreen20
Audiophiliac wrote:Bummer....too small. Back to Xtecs or ID CXS v2. Seems like they fixed the problems with dust getting in the gap...that is why I sold my old CXS62.
I'm sorry dog, my bad. It wasn't 5 7/16" it's 5 15/16". When I wrote it down, I subtracted 1/8" per side instead of added for the mount screw holes.