Page 1 of 1
enclosure size for Rsd 6 or 6.5
Posted: Mon Jun 22, 2009 1:04 pm
by Stryker
As the title states would like a ball park figure on this one, in litre's preferably but cu.ft is ok. The one's I have (kiks) are just to darn small at the moment. I'm running 5.25's but I'm gonna be grabbing 3 sets of Rsd's for the front, doors,and rear fill. i could get 6 for the floors or 6.5. I'm gonna go for 6.5 in the doors and use them strictly for midbass. the rears are gonna be 3.5.
thx
Posted: Mon Jun 22, 2009 1:11 pm
by stipud
Ideally I would say infinite baffle or ~.5cuft and up for the midbass... enclosures really seem to limit their bottom end. The 5.25's in your kicks can stay in a tiny enclosure, because the doors will be handling midbass anyways. Since you've already sealed and deadened them, they will be good to go.
Posted: Mon Jun 22, 2009 2:10 pm
by ttocs
half a cubic foot? alot of tens like that much airspace....... I like to use enclosures myself on my diamond audio hex speakers but I am not sure on these speakers.