Page 1 of 1
ti 600.2
Posted: Wed Jun 24, 2009 9:35 pm
by Killa_Cam
i got a 600.2 a couple of months back to run my components. everything works fine except the leds aren't working. how do you replace them? i bet it's easy, i just am not good at these things quite yet. any help is very much appreciated.
Posted: Thu Jun 25, 2009 6:32 am
by stipud
There's a little board that you can replace. Call PG up, they should have some left...
Posted: Thu Jun 25, 2009 11:17 am
by Killa_Cam
alright i'll give them a call, thanks.
Posted: Thu Jun 25, 2009 8:42 pm
by rolandk
Sorry, there are no more blue LED's available from PG. All thats left is a few circuit boards with mostly bad LED's that I have to sift through for amps in for service. See this thread
here on how to buy them.