Phoenix Gold Phorum

Posted: **Tue Jul 07, 2009 9:21 pm**

Does anyone know where to get one that would match the thermal led in the RMD system? it normally is blue, goes to purple when it is in thermal and red is overload.

Posted: **Wed Jul 08, 2009 6:16 am**

I'll bet the RDDP LED has two LEDs in it... one blue one red. In thermal it would just turn both on (which would look purple). It will be hard to match that to an actual purple LED.

Posted: **Wed Jul 08, 2009 6:23 am**

I might have an extra one laying around. I'll check.

Posted: **Wed Jul 08, 2009 8:51 am**

I am talking about the led for the rddp system that I use in my truck. the thermal one is blue for normal, purple for thermal protection and red for overload. What I want to do is swap out the single blue led in the remote voltage display with that one, and make a conversion harness for the voltage side so that I can "make" a RDDP voltage display since they are so hard to find.

Posted: **Wed Jul 08, 2009 10:14 am**

since they are so hard to find.

I just sold a pile of R-Link's and SDT's that were all NIB

Posted: **Wed Jul 08, 2009 2:56 pm**

I saw you sell one, and I couldn't afford it.

They are hard to find cheap is what I should have said. The only difference between the SDTs and the regular display is that led right?

Posted: **Wed Jul 08, 2009 3:00 pm**

ttocs wrote:I saw you sell one, and I couldn't afford it.

They are hard to find cheap is what I should have said. The only difference between the SDTs and the regular display is that led right?

Should have asked me about a trade, if you had something to trade that is

Posted: **Wed Jul 08, 2009 4:16 pm**

I'll give you my first born but with all the drugs I took in college don't get yer hopes up.

that led seems to be difficult to find. I have dug all over and can't seem to find a blue/purple/red led in any size.

Posted: **Thu Jul 09, 2009 3:58 am**

I forgot to look last night sorry. I'm 95% sure I have an extra one laying around.

Posted: **Thu Jul 09, 2009 4:54 am**

that would be cool if you did. Let me know $$$ shipped to phoenix.

Posted: **Thu Jul 09, 2009 5:25 am**

take an RGB LED and leave the G out?

Posted: **Thu Jul 09, 2009 6:27 am**

bretti_kivi wrote:take an RGB LED and leave the G out?

Yep that's what I was getting at.

Red + Blue vs a Purple LED will look different. So you probably need an RB or RGB LED if you want it to match.

Posted: **Thu Jul 09, 2009 7:26 am**

I thought about it and could have picked up the led at fry's but would rather make it more real.

I looked up RBP but it came up with a red-blue-pink led that was in the works....... That would be hot right

?

Has anyone ever taken a close look at the standard pg voltage display? just above the regular blue led is a missing resistor(R14) and there is also a missing transistor shaped device(3 solder point labeled Q1). does anyone know if there is a major difference between the this and the moradvanced display for the RDDT with the thermal monitoring led?

Posted: **Fri Jul 10, 2009 4:59 pm**

hey dwnrodeo, any luck? I need it for my most recent project and I think it will be cool as hell when its done.

http://www.cardomain.com/ride/3237206/2

Posted: **Mon Jul 13, 2009 4:23 am**

Damn, forgot again! I am writing myself a note right now to check for it tonight. I apologize about this.

Posted: **Mon Jul 13, 2009 11:05 am**

I MIGHT have found a replacement but these seem hard to find.....

Posted: **Tue Jul 14, 2009 4:25 am**

Sorry, I checked last night and I don't have any more. I must have included them with the two RDDP/SDT kits I sold a couple months ago.

Posted: **Tue Jul 14, 2009 5:19 am**

ah that sucks as the source I had, I don't have anymore.........

Anyone have any ideas where to get these leds?

Phoenix Gold Phorum

blue/purple/red tri-color leds?

blue/purple/red tri-color leds?