Phoenix Gold Phorum

Hey folks my first post here. Planning a system in my A4 wagon based around all of the PG RSD line. But I have a few questions regarding subs. Originally I planned for a pair of RSDC 12's in a 2.3 cu.ft. enclosure which fits fine. However, I re-arranged a few things and looks like I can fit nearly a 4 cu. ft. (before displacement)enclosure. My question is I know PG recommends 2.5 cu. ft/sub vented for SQ. I'm looking for more of an SQL type enclosure. What do you guys think of ~1.75 cu.ft. net vol./sub tuned to 34-38 hz. ? Will the lower enclosure volume kill my bottem end?
Opinions? Thanks!

watch this http://www.youtube.com/watch?v=D7pUwlg2d14 itll give u an idea what a RSdC12 will do in a 2.3 cuft (before sub) with a port tuned around 27-29hz powered by a Ti600.2 bridged @ 8 ohms (300 watts rms) will do hope this helps. also I took the rubber boot off the magnet and used a polylining in the box heres my install link http://phoenixphorum.com/my-install-fin ... 10941.html hope this helps.

haha, that was awesome watching the volts drop....

Hey thanks knightrider! Awesome video and install. Sounds really good to. From the looks of it you're probably right around 2 cu.ft after sub and port displacement and the bottom end didn't suffer. Looks like your tuned fairly low as well. I think I may just go with the 4 cu. ft. box tuned around 29-32Hz. Ports are gonna be fairly long but I think I can get away with it. I'm gonna be running two RSDC122's on a RSD1200.1 @ 2ohms so I hope have enough power.

knightrider358 wrote:watch this http://www.youtube.com/watch?v=D7pUwlg2d14 itll give u an idea what a RSdC12 will do in a 2.3 cuft (before sub) with a port tuned around 27-29hz powered by a Ti600.2 bridged @ 8 ohms (300 watts rms) will do hope this helps. also I took the rubber boot off the magnet and used a polylining in the box heres my install link http://phoenixphorum.com/my-install-fin ... 10941.html hope this helps.