Rsd 1200.1 stable at 1 OHM ??
Posted: Sat Jul 18, 2009 7:53 pm
Can't find the answer to this maybe someone has tried. is it stable at 1 OHM? I'm thinking it should be as most class D's are... then again not sure.
thx
thx
Phoenix Gold Phorum
Celebrating the Phoenix Gold legacy, and oldschool car audio!
https://www.phoenixphorum.com/
Rsd 1200.1 stable at 1 OHM ??
Page 1 of 1
Posted: Sat Jul 18, 2009 7:59 pm
I don't think it is dood.....
Posted: Sat Jul 18, 2009 8:06 pm
found the answer. better not to try it 
when will this car audio ever be loud enough?
when will this car audio ever be loud enough? Posted: Sat Jul 18, 2009 8:20 pm
Loud enough..........................
huh?.....what'd you say.......???????
huh?.....what'd you say.......???????
Posted: Sat Jul 18, 2009 11:59 pm
seriously any amp will do nearly any load (unless it has short protection) its not until you push it into thermal or clipping it will become a problem... real fast...
Posted: Sun Jul 19, 2009 10:13 am
it can do it for a while....but it isnt something i would run it on everyday.
as really loud said, any amp can handle any load to a point. what will happen is it will pull more current at lower loads. which creates more heat. so as soon as you reach the point where its pulling more currant then heat sink and/or fans can dissipate....you got problems
as really loud said, any amp can handle any load to a point. what will happen is it will pull more current at lower loads. which creates more heat. so as soon as you reach the point where its pulling more currant then heat sink and/or fans can dissipate....you got problems
item
Posted: Mon Jul 20, 2009 5:22 am
Corey just buy new subs
don't damage your new amps
also if you find the right sub for the box size. I turly feel most 15 need alot more than 2.5 cub ported
even my jl 15 in the theater room said it need 4cub ported and 2-2.5 selaed
don't damage your new amps
also if you find the right sub for the box size. I turly feel most 15 need alot more than 2.5 cub ported
even my jl 15 in the theater room said it need 4cub ported and 2-2.5 selaed
Re: item
Posted: Mon Jul 20, 2009 2:14 pm
kg1961 wrote:Corey just buy new subs
don't damage your new amps
also if you find the right sub for the box size. I turly feel most 15 need alot more than 2.5 cub ported
even my jl 15 in the theater room said it need 4cub ported and 2-2.5 selaed
ya thats the route to go.... I don't want to be let down by 12's tho.... so the box is what it is. got it all sealed up after I discovered a few leaks because the subs weren't seated v. good. much nicer now. the T/S sheet I have recommends 2.0 Cu FT for these with a 10.39l and 4 inch port for a tuning freq of 35 Hz wish i had dual 4 VC tho. I would be happy then.