Page 1 of 1
Line driver before or after bass cube??
Posted: Wed Jul 22, 2009 8:27 pm
by james--hughes
Should I install the line driver before or after the bass cube? Thanks for all the help too guys. It has been super helpful.
Posted: Wed Jul 22, 2009 9:13 pm
by ttocs
I thought the cube already boosted the voltage?
Posted: Wed Jul 22, 2009 9:30 pm
by james--hughes
oh maybe it does? I thought you could use both, but maybe not??
Posted: Wed Jul 22, 2009 9:40 pm
by AVICJR
Line driver before Bass Cube. Install it as close to HU as possible.
Posted: Thu Jul 23, 2009 4:25 am
by fordtough1
^^^^what he said^^^^
Posted: Thu Jul 23, 2009 4:26 am
by fordtough1
^^^^what he said^^^^
Posted: Thu Jul 23, 2009 4:29 am
by Stryker
Bass CUBE does not have a line driver. Install close to HU
Posted: Thu Jul 23, 2009 5:59 am
by smgreen20
The BassCube uses unitygain, meaning what's put in is what it puts out. Example, 1v in/1v out, 12v in/12v out.
So yes, put the BassCube after the line driver. Besides, the BassCube would normally be installed in the trunk/rear of the vehicle which is why a line driver would be needed anyway.
Posted: Thu Jul 23, 2009 3:34 pm
by james--hughes
Thanks guys. I have it hooked up like that right now. I am trying to find a TLD 66 to replace the current driver so I can boost the signal to both my other lines for my front and rear stage too.
Posted: Thu Jul 23, 2009 4:07 pm
by ttocs
I was wondering why you would want to boost just the bass signal unless you were going for a strictly spl use.
Posted: Thu Jul 23, 2009 5:52 pm
by smgreen20
He does state he's going to get a TLD66 to replace the one he has, so at that point it will be all but, I do see your point- the one he has now was bought and used.