Page 1 of 1
Will the SDT display work without an R-Link?
Posted: Sun Aug 02, 2009 1:21 pm
by hybridamp
In regards to the Titanium amps, can you plug in one SDT display directly to the RDDP port of a Titanium amp without the use of an R-Link?
Thanks.
Posted: Sun Aug 02, 2009 2:47 pm
by ttocs
you need to make an adaptor for it but it can work. Here is the pin-out of the rddp.
http://download.phoenixphorum.com/TechS ... Pinout.pdf
On the sdt I think it comes with a pin out, pin 1 and 3 are hot(I think) and 2 and 4 are ground(again I think)
I am trying to locate the source of the red/blue/purple leds that come in the rddp kit in the lounge forum(They will not ship out of england). You could swap out the blue led with one of these and wire it up to make your sdt have the thermal monitoring as well.
Posted: Sun Aug 02, 2009 3:11 pm
by hybridamp
Cool, thanks for the info.
Posted: Sun Aug 02, 2009 5:18 pm
by knightrider358
heres what the RDDP pin out equate too, using a rj45/cat5 cable this might help a whole lot I hope
http://phoenixphorum.com/cat5-rj-45-wir ... 11030.html