Page 1 of 1

ZPA0.5v2 setup opinions/help

Posted: Wed Aug 12, 2009 1:27 pm
by yeddy
I am currently designing the audio setup for my car. I bought a ZPA 0.5 a while back, now it's time to use it! for subs I have
2 12" JL w3
1 12" JL w7
I also have the choice of buying 2 12" Hertz High Energy HX300D, which would match all my speakers.

Now all that said, if I keep the JL subs should I do Tri-Linear mode? should I run the w3's in stereo and the w7 mono?
the w3's are dual 2ohm vc
the w7 is 3 ohm svc
OR
Just a single w7 mono?
OR
Do I sell all those subs and get the 2 12" Hertz High Energy HX300D dual 4 ohm?

Posted: Thu Aug 13, 2009 3:50 am
by cyberpunky
If its about SPL use the w7(and I think you can mod amp for more power). If you want best SQ go the 2 W3s. The W3s should pound off that amp. If you wire subs in series/parallel you will show amp 2 ohm load, The ZPA can eat that for breakfast.

I wouldnt bother with tri-mode as there is no free lunch(you will end up with all subs seeing less power), and its never good to mix subs playing same freqs(it will sound like a$$).

Personally I'd stick with JLs

peace
Cyberpunky

item

Posted: Thu Aug 13, 2009 5:16 am
by kg1961
I would say the same I have never heard the other subs
I owned the w7 and alot of w3
what version of w3?

Posted: Thu Aug 13, 2009 6:38 am
by stipud
I am not sure if tri-linear mode is possible or not in your case. The W7 will cause a 1.5 ohm stereo load, so adding two more 4 ohm loads in parallel may work in theory.

You shouldn't mix types or sizes of subs, as it causes cancellations, which cause dips in your frequency response. Considering these speakers will all be playing the same frequency, since you cannot cross them over differently, then I do not think it's a good idea.

Posted: Thu Aug 13, 2009 6:40 am
by joerg
If running it in tri linear mode i would get one of those XRV passive crossovers from PG! 8)

Posted: Thu Aug 13, 2009 7:28 am
by stipud
joerg wrote:If running it in tri linear mode i would get one of those XRV passive crossovers from PG! 8)
What for? Its crossover range is too high for subs.

Re: item

Posted: Thu Aug 13, 2009 6:06 pm
by yeddy
[quote="kg1961"]I would say the same I have never heard the other subs
I owned the w7 and alot of w3
what version of w3?[/quote]

They are v1, last batch before the v2 came out...

item

Posted: Fri Aug 14, 2009 5:30 am
by kg1961
very nice than you will like them alot. just what out for the foam on them they crack when they get older or miss used

Posted: Fri Aug 14, 2009 4:57 pm
by smgreen20
And if you do the mod, you can't, or shouldn't, go below 2 ohms mono as you bypassed the circuit that would keep it from frying itself.

You might find, as I did, that you wont even need the mod done at 2 ohms. Mine hasn't switched modes since it's been in 2 ohms mono.

Just stick w/the W3's.