Phoenix Gold Phorum

So I need a little help understanding this distro. The set screw input on the bottom right corner, is that a ground or a remote? And if it's a ground, do the led's stay on permanently then?

And what does the small switch above the set screw do? Does that enable/disable the led status?

And I think this will take an RMD voltage status display, right?

I was talking with Matt, and he mentioned the thought you had to do something to get the RMD to work.

Any help's appreciated, thanks.

The screw in the bottom left corner is ground! The leds stay on as long as u have the switch above turned on!

If u connect a voltage display to the RMD jack it won´t work and only show´s LO all the time! This distro block only works with the ZRDT3.
This is only a status led that changes colour when the voltage drops!

You´ll find everything in here!

http://phoenixphorum.com/tirmd-ti-d-blo ... rmd+issues

Sooo to summarize, is the general consensus:-

AGU\PGU fuses = ZRD3
KF Fuses = Ti RMD & SDT?

Thanks joerg! I take it you don't have to ground it if you don't care about the LED's?

I probably won't worry about the ZRDT3 if it's just led's and not a RMD type thing, but PG 4 Ever has some if you are looking...

Still wishing mine was the KF fuse version honestly.