Page 1 of 1
Quick one! ZPA Plexi question...
Posted: Mon Aug 17, 2009 4:06 am
by phoenix_rising
Does anyone know whether the plexi from a ZPA 0.5 will fit a 0.3???
Posted: Mon Aug 17, 2009 5:49 am
by rscecil007
I don't think so b/c the 0.5 is longer by about 2 inches I think.
But PG did have some 0.3 plexi's left about a month ago if that helps.
Posted: Mon Aug 17, 2009 5:54 am
by phoenix_rising
Cheers dude - i should have looked at the zpa before i posted that! as i knew the difference in size between 0.3 and 0.5..Cheers for pointing it out though!
Posted: Mon Aug 17, 2009 8:05 am
by marko
no, differant sizes..
Posted: Mon Aug 17, 2009 8:07 am
by phoenix_rising
Cheers Marco - shame...id found a 0.5 plexi, and was hoping i could blag it onto the 0.3
Posted: Mon Aug 17, 2009 8:11 am
by rscecil007
phoenix_rising wrote:Cheers Marco - shame...id found a 0.5 plexi, and was hoping i could blag it onto the 0.3
You might want to pick up that 0.5 plexi though if it's in good shape, for safe keeping or to trade. I think those are the ones that are hard to find nowadays.
Posted: Mon Aug 17, 2009 8:20 am
by marko
they always have chipped corners due to idiots over tightening them
Posted: Mon Aug 17, 2009 8:24 am
by rscecil007
marko wrote:they always have chipped corners due to idiots over tightening them
Yeah, it's pretty rare to see one up fro sale with unbroken plexi. I've only seen a few.
Posted: Tue Aug 18, 2009 8:09 am
by smgreen20
You could cut 1" off of each end and redrill the NEW holes on the 4 corners to fit the 0.3 If you needed to. Clean and buff your edges after you cut and use plenty of lubricant when drilling/cutting.
All I have is a clear 0.5 cover.
Posted: Wed Aug 19, 2009 9:29 pm
by Jim Truett
I have an extra smoked 0.3 plexi but there are stress cracks around the screw holes. I can post pics if there is interest.....
Posted: Thu Aug 20, 2009 1:01 am
by phoenix_rising
Thanks Jim - im really looking for some newish ones as im trying to overhaul the 0.3's with swirless plexi's
