DIFFERENTIAL-BALANCED INPUTS

bruther · Post by **bruther** » Tue Aug 18, 2009 9:27 am

Does anyone know if titanium amps accept DIFFERENTIAL-BALANCED INPUTS?
Thanks
Brian

bruther · Post by **bruther** » Tue Aug 18, 2009 6:48 pm

Someone has to know if PG ti amps accept balanced inputs?

rscecil007 · Post by **rscecil007** » Tue Aug 18, 2009 6:52 pm

I don't think so, I think the only ones I know that took a balanced input were ZPA's. At least out of the older stuff, the newer lines I'm not familiar with.

bruther · Post by **bruther** » Tue Aug 18, 2009 6:56 pm

thank you!!!

bruther · Post by **bruther** » Tue Aug 18, 2009 6:59 pm

Do you know if the PLD1 will accept balanced signals?

rscecil007 · Post by **rscecil007** » Tue Aug 18, 2009 7:11 pm

bruther wrote:Do you know if the PLD1 will accept balanced signals?

I don't believe it will. The older PG stuff either used CAT6 connectors, or the PS2 controller type connectors for all their balanced inputs/outputs, IIRC.

The PLD just takes normal input and does a normal output.

The Tbat takes a normal input and converts it to a balanced output, but you have to either have the Tbat receiver, EQ 232, or something else that will take a balanced input to use it.

Hope this helps, and someone please correct me if I am wrong on any of this.

Post by **ttocs** » Wed Aug 19, 2009 2:40 am

I think You are wanting to look into the balancing act I think(TBAL) by PG. This will take the rca outputs, change it into a balanced output with the transmitter, this goes as close to your deck as possible and will also boost the voltage. If your amp does not have balanced inputs then you will want to look into the receiver unit that goes as close to your amp as possible.

bruther · Post by **bruther** » Wed Aug 19, 2009 3:11 am

Thanks. the reason why I ask is that I currently have a G35 that I am using the factory radio. I got rid of the factory amp and am using the low level voltage signals from the factory radio. I was told that those were balanced signals coming off of my factory radio. I am currently using the PG SL44 and I do not like it. I do not like the individual input level controls on it. So I want to either get rid of it completely or replace it with another LOC. For the sake of saving money I wanted to see if I could just plug the signals directly into my amps........Thanks for the responses.
Brian