Page 1 of 1
PG QX900.1D resistor values?
Posted: Tue Sep 08, 2009 1:40 pm
by charles75212
Hello. I am new to this forum. I'm repairing a PG QX900.1D amplifier and the two resistors(R307 & R308) are burned beyond recognition. I believe that both are the same value. Any help is greatly appreciated. Thanks.
Posted: Tue Sep 08, 2009 2:18 pm
by Bfowler
you will have to hope someone will take pictures for you. they dont even have it on amp guts.
also, it should be very similar to the octane-r 1500.1 so you might be able to get some insight if someone knows those values
good luck!
Posted: Tue Sep 08, 2009 9:19 pm
by bretti_kivi
there should be some pics on here of mine.....
Posted: Tue Sep 08, 2009 9:23 pm
by bretti_kivi
PG qx900.1D resistors
Posted: Wed Sep 09, 2009 12:03 pm
by charles75212
Hello Bret. The 2 resistors are in the middle of the two large black capicitors and the red mylar capacitors. They are directly beside each other in parallel. I can't see the color bands on the resistors from the pictures to determine the values. The locations are R307 & R308. Your assistance is greatly appreciated. Thanks.
Charles
Posted: Wed Sep 09, 2009 12:34 pm
by bretti_kivi
ha, I have the original res version of that shot
- yellow, purple, gold gold. The left one on the pic also has gold gold at the end. 4.7Ohms, 5% tolerance, they're big ones, too.
Bret
PG QX900.1D Resistor values
Posted: Wed Sep 09, 2009 3:32 pm
by charles75212
Thanks very much Bret. You're a life-saver.
Posted: Tue Nov 16, 2010 11:35 am
by Daimao
just to verify those two resistors R307 and R308 are they 4.7 ohm 2watt 5%?
Another answer said they were 4.7K.
Thanks