Phoenix Gold Phorum

some help needed again frens,
i read thru errin's write-up on gain setting with DMM.

IT's been of great help.
i've been adjusting my gains with the x-over and ssf filters enabled.

Is this correct or do i have to bypass the filters, adjust the gain ,then enable and get to the crossovers ?

pls help. Thanks again

If your SSF is below, and the LPF is above the frequency you tested it at (50 to 60Hz), then you will be fine. I think the SSF is set at 25, and you probably had your LPF well above 60 as well, so you should be good

thanks stipud,
set my SSF around 25Hz and LPF at 70, guess i'm ok then.