RSD10D's

Irongoats · Post by **Irongoats** » Sat Oct 24, 2009 8:40 am

What are you guys using to power them? I swapped these out with the regular 10's but they don't hit like the older ones. Currently using the V752 (not enough power?) with a bass cube. I'm stumped, it's like listening to a stereo that the bass was cut out. The amp powers up as does the cube just perplexed.

Post by **Bfowler** » Sat Oct 24, 2009 12:43 pm

you swapped in the rsdc's in place of the rsds?

i have powered them on as little as 300watts.

they are more efficient so they should be louder on the same power. the v752 is a little low for them though. do you have the d4 or d2? how is it wired to the amp?

Irongoats · Post by **Irongoats** » Sat Oct 24, 2009 2:12 pm

I meant to say took out the Ryval 10D's for the RSD10D's. They're in a downfire box under the seat so the wiring from amp goes to the connectors on the box then split from there to each speaker.

Post by **Bfowler** » Sat Oct 24, 2009 7:48 pm

ah, no the ryvals are VERY efficient. they will definitely be louder on that amp. the rsd's should play lower at least!

the rsd's can take well over twice the power though. i wou.d wait until you get a bigger sub amp, then move the v752 over to your speakers

Irongoats · Post by **Irongoats** » Sat Oct 24, 2009 8:22 pm

That's what I was thinking under powered for that amp and speakers. I'll swap them back out and wait to see what's in the pipeline before I make another purchase.