Page 1 of 1
Help with install
Posted: Wed Dec 30, 2009 10:42 am
by Rob221
Hello guys!A few weeks ago I asked for help installing a TLD22 and got good help (see my post Help with TLD22 install).So for Xmas I got a V8001.Was wondering how to put this all together and make it right.Do I still install the TDL22 as stated in my last post?Or do I install the LPL in to the V8001.Also on the X200.4 there is a 2 ch 4 ch button where should I have this set?If someone could walk me through how is the best way to set this all up it would be greatly appreciated have an Alpine 9856,X 200.4 and a V8001,CDT components in the doors and 2 RSdC102 subs in the rear.
item
Posted: Wed Dec 30, 2009 5:43 pm
by kg1961
use the lpl for the sub so if you going to use the v800.1 for subs use it there
let us know what you are using for high and lows
i would use the line driver to the 200.4 use 2channel setting for highs
Posted: Wed Dec 30, 2009 6:12 pm
by audiophyle_247
This could get confusing, but here goes.
Connect the Alpine's front RCA outputs to the TDL22, then the TDL22 output to the X200.4 front input, set the 2ch/4ch selector to 2ch, then run the output from the X200.4 to the V800.1, plug the lpl into the V800.1 lpl port & walla.
That is probably the best way to hook up what ya have & get the most out of everything.
Posted: Wed Dec 30, 2009 6:40 pm
by Rob221
Thanks again audiophyle_247.Not confusing at all.What would be the best way to wire subs to V8001?
Posted: Thu Dec 31, 2009 10:04 am
by audiophyle_247
Depends on the voice coil configuration.
Check out
www.the12volt.com
You can find wiring diagrams to show you how to wire them.
Posted: Thu Dec 31, 2009 11:24 am
by Rob221
Ok i have 2 RSDC102's.So would this be the best way to hook them up to the V8001?