Page 1 of 1
Aluminum speaker Rings
Posted: Thu Feb 04, 2010 2:55 pm
by bruther
Is anyone able to cut aluminum? Let me know?
Brian
Posted: Thu Feb 04, 2010 4:02 pm
by ttocs
you can do it with a standard router and some good bits as long as you go slow and keep the bit cool.
Make it out of wood and then just transfer it to metal.
Posted: Thu Feb 04, 2010 5:35 pm
by Jacampb2
Yes, I can CNC cut aluminum. What are you looking for? If it needs to be out of anything thick, you may not like the idea of what it will cost...
Posted: Thu Feb 04, 2010 5:47 pm
by bruther
Jacampb2 wrote:Yes, I can CNC cut aluminum. What are you looking for? If it needs to be out of anything thick, you may not like the idea of what it will cost...
I need two rings to be about 1/8-1/4 inch thick
Outer hole- 4.65 inches
Inner hole- 3.75
Let me know how much that would run?
My hope is that the inner part has a beveled edge.
Let me know if you can do it?
Brian
Posted: Thu Feb 04, 2010 6:27 pm
by andy600rr
Did'nt Vin do his with an inner bevel with a router???
http://phoenixphorum.com/new-car-instal ... 00-50.html