Phoenix Gold Phorum

Ok , here is the scoop .

There is a member here that approached me Via PM about getting something going on remaking the MS connections , and he sent me 2 for visuals .

Would there be a big interest for them ?

As I plan on meeting with my source monday so he can write the CNC program , and what not .

The only noticeable difference will be the mounting " ears " as we want to beef them up a 1/4 inch or so .

Keep in mind these will be cheaper the first run . And I would like to get some input on it ......


Here is the questions I have currently .

see image below , It looks to be symmetrical to me . if not can someone post a pic of one of each mounted ( need pics of the inside of the case for clearance )

I know I need 4 speaker terminals, 2 power and a few of each for the hell of it

I should have some ballpark prices per piece tomorrow ....

I would asume ther would be a big interest as these are hard to find. Lets get this done... and kudos to slick and his side kicks

Met with my guy today .

Will be a couple days till I get anything nailed down .

The snow is forcing me to work alot more ......

Eric D. is also working on the remake of these parts.

who ever does it...I will be on board for full sets of power and speaker terminals for an ms250 and an ms2125.....if it isn't to much cash....

If your builder needs end plates for templates I have extras for 275's, 250's and for 2125's....both ta and os.....I would need them back but know it is an option

Finally a small update .

The cnc program is written for the speaker terminal ......

WOOT WOOT ....