opinions wanted

[todd217]

what would you guys do 3 m25 on 3 jl 10w6v1 at 3ohms mono each or 1 side of my ms1000ta running all 3 at 4ohms mono. or ms1000 running a single stereo integrity mag 12v3.

[joerg]

Running the 3 jl´s with the M25´s and move the TA into the buy/sell section

[STROKD]

what would you guys do 3 m25 on 3 jl 10w6v1 at 3ohms mono each or 1 side of my ms1000ta running all 3 at 4ohms mono. or ms1000 running a single stereo integrity mag 12v3.

the 3 10s off one side of the 1k, the other side of the 1K to some mid bass, and the m25s to the tweeters and 4 or 5 inch speakers... the 1K even half of it would blow a 12w3 imo if u leaned on it, and if u played it at like 8 ohm or real low gain, it'd be a waste of that amp imo.

[todd217]

Running the 3 jl´s with the M25´s and move the TA into the buy/sell section

i will sell it if i go the m25 route. its just been so long since a had a m25 about 15 years i just wanted to make sure i was not overestimating the m25. Stroked they are the w6s not the w3s. also a m44 will run the fronts active withe the m25 route. this is going in a 98 stang.

[joerg]

Running the 3 jl´s with the M25´s and move the TA into the buy/sell section

i will sell it if i go the m25 route.

I really didn´t expect that answer Keeping my fingers crossed and hope u´ll use it. Otherwise i´m in troubles

[todd217]

i will be a while the heatsink is on its way to Matt. also i have new endplates and a better plexi that Phil hooked me up with when they fixed a few issues. if i sell it i will pm you first b4 i list it.