Page 1 of 1
so help set up my amp....
Posted: Mon Mar 08, 2010 6:58 am
by Pug}{maN
MB Quart DSC2150 Discus Series 2-Channel AMP, need help with seting it up, i have no clue on how to do it. i numbered all the settings 1 2 3 4 5 to help. it will be running 1 pg rsdc 12 2 ohm, the amp will be at 4ohm x 1 at 600w rms...
Posted: Mon Mar 08, 2010 7:26 am
by joerg
1: Set it to 0 to start with
2: Set it to LP/BP Mono
3: Turn it up half way between 30Hz and 150Hz. Should give you arround 75HZ
4: No need to adjust this one for sub duties.
5: Set it to the lowest possible point to start with. Adjust your radios volume as high as you front speakers can take it (Even stay a little lower so you won´t damage them) and start to match the sub output by turning this poti so it matches with your frontstage.
I hope that helps.
Posted: Mon Mar 08, 2010 7:40 am
by Pug}{maN
sounds good to me..thanks...
Posted: Mon Mar 08, 2010 8:26 am
by stipud
One small correction... for #4, set that as low as possible. From the looks of it that knob can be used as a subsonic filter (i.e. it goes as low as 10Hz). The LP/BP setting probably uses both the low and highpass settings.
Posted: Mon Mar 08, 2010 8:48 am
by Pug}{maN
ok
Posted: Sun Mar 14, 2010 2:50 pm
by eazy-e
im glad i got rid of my maxxsonics amps, they are very over rated atleast my bxi1208d, it was supposed to be 1200watts at 1 ohm, and it seemed like alot less than the rear channel of my zx450 bridged at 4ohms!!!