Page 1 of 1
line driver question
Posted: Sun Mar 21, 2010 11:25 am
by 12voltjunky
would a single 2 channel line driver
work to drive a pair of PG ti amps
if using the outputs from one amp to
take the signal to the input of the other amp?
Posted: Sun Mar 21, 2010 11:28 am
by AVICJR
Yes, it will work for both. What goes in is same that comes out.
Posted: Sun Mar 21, 2010 11:41 am
by 12voltjunky
thanks for the quick reply.
my head unit has two sets of outputs.
if I ran a 4 channel LD, would the only
advantage be fader/bal control?
Posted: Sun Mar 21, 2010 11:48 am
by AVICJR
You are correct. You will be able to keep the fade function control through your HU.
Posted: Sun Mar 21, 2010 11:57 am
by AVICJR
After thinking about it some...... you can also use the xover in the first amp to send a HP/LP signal to the next amp.
Posted: Sun Mar 21, 2010 12:05 pm
by 12voltjunky
AVICJR wrote:After thinking about it some...... you can also use the xover in the first amp to send a HP/LP signal to the next amp.
I plan to use that feature as I am
rewiring a few things. Thanks for your input!