Page 1 of 1
take a look at this....
Posted: Mon Mar 29, 2010 6:15 am
by Pug}{maN
got to look'n at my rsdc, and seen that the pice with holes in it up in the hole in the magnet is bent up in to the cone , its not tuching it, but i have not put power to it yet.
should i try to pull it back down ? or leave it, or send it back ?
Posted: Mon Mar 29, 2010 6:36 am
by Eric D
Send back.
That should be glued all around its perimeter so it never comes loose.
fef
Posted: Mon Mar 29, 2010 12:11 pm
by kg1961
Eric D wrote:Send back.
That should be glued all around its perimeter so it never comes loose.
x2
Posted: Mon Mar 29, 2010 2:02 pm
by smgreen20
With the pressure that could be present moving in/out through the pole piece, it could make that fall out then it's like having a dropped valve in a cylinder of a car. You know what'll happen after that.
Posted: Mon Mar 29, 2010 2:16 pm
by scottn29
You might be able to fix it yourself, if where you bought it from wont take it back. We are talking about the screen in there correct? I would either pull it on out or see if you could get a pick up in there to pull it back down and re glue it yourself.
I would send it back if possible, but if you remove it, it wont affect anything as its just there to stop debris from getting in there, out of all the woofers I have ever used, I have never gotten anything in the pole vent.