Page 1 of 1
Which amp to use for Ti Elites.
Posted: Fri Apr 02, 2010 12:27 pm
by gbody805
Ok did some searching and didn't really find a complete answer.
Maybe I didn't word the search right.
Ok here goes.
I have a set of the 6.5 ti elite comp speakers. I also have a set of the 9" elites to go with them.
Which would be a better choice for the 6.5s?
A Xenon 200.4 bridged, a zxti600 , a Ti1000.2?
Also what should I be on the look out for to run the 9" elites?
Any thoughts would help very much.
Posted: Fri Apr 02, 2010 12:32 pm
by Bfowler
i would say the ti600.2
they have neo magnets that get HOTT and demagnetize. running more then 200watts to them is just waste and will lead to premature magnet failure
i had to buy a new set of mids for my set.
the xenon fronts of the 200.4 would be fine and then you could run ti9's of the rear channels
Posted: Fri Apr 02, 2010 12:39 pm
by gbody805
Thank you.
I wasn't sure if I had to run what was advertised as RMS or could get away with a little less.
Posted: Sat Apr 03, 2010 12:19 am
by longboard
200.4 run the 6/1 of the front channels passive and the 9s of the rear channels active
Posted: Sat Apr 03, 2010 12:33 am
by stipud
x3 on using the X200.4. It was pretty much made for that setup! Its crossover functionality will be perfect.
Posted: Sat Apr 03, 2010 9:02 am
by smgreen20
x4 for the X200.4
That was my first thought.
item
Posted: Sat Apr 03, 2010 9:07 am
by kg1961
smgreen20 wrote:x4 for the X200.4
That was my first thought.
make that 5x
Posted: Wed Apr 07, 2010 1:14 am
by dontlookatme
damn i have the 6.5 in the front and the 5.25 in the back both running on their own 600.2 am i giving them too much power?
Posted: Wed Apr 07, 2010 5:29 am
by smgreen20
No. The 600.2 would be a good match for them. I was giving mine 225 per side and no issues.
Posted: Wed Apr 07, 2010 8:34 am
by Bfowler
nope, 600.2 is pretty much perfect imo