Page 1 of 1
ms amps
Posted: Fri May 07, 2010 3:25 am
by JK
why does the ms250 have green wires like ms2250 and not red wires like the ms275,mps2125,mps2500 ect.. what is the difference between the 2?
Posted: Fri May 07, 2010 4:19 am
by mhyde71
do you have pic to show what your referring to exactly...? you mean on the transformer or the speaker coil thingy ...?
I am not sure i can say that i have ever seen a green wired anything in a 250
Posted: Fri May 07, 2010 7:04 am
by stipud
Back in the day, PG would use whatever they had lying around. Finding two matching M's or MS is like finding two of the same snowflake
Posted: Fri May 07, 2010 7:38 am
by marko
stipud wrote:Back in the day, PG would use whatever they had lying around. Finding two matching M's or MS is like finding two of the same snowflake
true on the ms2250 and zpa's but i have never seen green wire on an ms250/275 or 2125..
Posted: Fri May 07, 2010 9:25 am
by mhyde71
neither have I ^^^^^
Posted: Fri May 07, 2010 10:08 am
by stipud
Hell i've seen green wire in M series amps too. If they ran out of red they would use green in a pinch. PG was basically built out of a garage for the first while. The earliest revisions of these amps had the most variety, but even the late models have quite a few differences, even within the same revision.
Posted: Fri May 07, 2010 10:32 am
by JK
how do i post picts? that board and a 2250 would look good in the same sink. i should hold on to that one. ill post it!
Posted: Fri May 07, 2010 10:33 am
by JK
the coil! i never looked under the tape