Page 1 of 1
Ti trivia
Posted: Fri May 07, 2010 3:09 pm
by yeddy
Anyone know the L.E.D. values for the trilight? One of my amps stopped lighting up and I really need to fix it. Does it matter how many MCD's the L.E.D. is? I have alot of Blue 8000MCD L.E.D.s and would like to replace them in all my amps, but I don't want to burn anything out. These are waaaaaaaay brighter then the original ones.
Posted: Sat May 08, 2010 12:36 am
by eulogious
LED's use minimal power no matter the brightness, so it shouldn't be an issue. I would guess that you should be ok, I can't see the LED's using so much power it messes something up, but I could be wrong, since I don't actually own that amp...
Posted: Sat May 22, 2010 3:24 am
by trl2112
I was told (on here) they are T1 3mm superblue led. I have some, but not installed them yet.
Posted: Sat May 22, 2010 3:52 am
by eulogious
Exact replacement found at digikey:
http://search.digikey.com/scripts/DkSea ... &x=25&y=24
The resistor is what controls the brightness... or so I am told. Hope that helps!
Posted: Sat May 22, 2010 4:48 am
by mhyde71
^^ correct ^^ those will work fine- but you will want to replace all three as there is just a slight difference - they are much brighter that oem- i say much- but perhaps should be just a little brighter... BUT looks great with these also!
Posted: Sat May 22, 2010 4:57 am
by ttocs
as he said I replaced the leds on my octane le with those, but do all 3. Its not big deal.
Posted: Sat May 22, 2010 9:13 am
by MW3
If they have not failed no reason to replace them...
If they have failed be sure to check the screws mounted the pcb to the back of the crossover card. They carry the 12v and ground to the LED pcb.
Posted: Sat May 22, 2010 11:39 am
by yeddy
I replaced the LED's cuz 1 of them burnt out due to rubbing the edge of the hole. Any one know where to get replacement fans with 3 LED's in them? I want to replace them in all my amps, only problem I can't find any 80mm x 80mm x 15mm. I can only find 80x80x25....