Phoenix Gold Phorum

will it work on say a zx950 or a octane le? all i read is the unit that is seperate and cost like 200 if i get one i would not want to spend that...
let me know how had used it if it works

also there was a member here that had a zx950 install in the trunk with one of 2 rmd looking item above the amp who are you?

you can use the rmd on any amp if you cut the one end off.

The original zx amps did not have the plugs but the Ti amps did.

The ZX amps do have a plug for it. My 450 does. If it's what I'm thinking. RDM and LPL plugs.

Pretty sure the RMD works on the Ti distro's that use the KF fuses as well.

rscecil007 wrote:Pretty sure the RMD works on the Ti distro's that use the KF fuses as well.

It works on any distro with a minor change that takes a soldering iron, about 2 inches of wire and 10minutes of time

so what would i have to do to make it work on say a zx950 the sub side?
I can soilder so not problem there wiring or drawing please

kg1961 wrote:so what would i have to do to make it work on say a zx950 the sub side?
I can soilder so not problem there wiring or drawing please

I´ll get u all the info and pic´s tonight mike!

thanks man can't be that hard is it? just change a differnt end Im guessing

The small Ti amps only have an RDDP port unfortunately

So you need to convert this:
http://download.phoenixphorum.com/TechS ... Pinout.gif

To this:
http://download.phoenixphorum.com/TechS ... Pinout.pdf

so just 5 and 7 on the rddp than and make it the 4 pin rmd on the phone jack?

RDDP, My bad.

stipud wrote:The small Ti amps only have an RDDP port unfortunately

So you need to convert this:
http://download.phoenixphorum.com/TechS ... Pinout.gif

To this:
http://download.phoenixphorum.com/TechS ... Pinout.pdf

I will be doing this for a friend coming up here soon, so looking at those diagrams, on the RDDP you only need pins 5 and 7 wired to pins 1 and 3 on the RMD, and the other 2 from the RMD you just ground? Is that how it works?

joerg wrote:

rscecil007 wrote:Pretty sure the RMD works on the Ti distro's that use the KF fuses as well.

It works on any distro with a minor change that takes a soldering iron, about 2 inches of wire and 10minutes of time

Very true, but it just plugs into the Ti KF block with no modification needed right? I swear I read that on here....

RMD pins 1&3 to RDDP pin 5
RMD pins 2&4 to RDDP pin 7

stipud wrote:RMD pins 1&3 to RDDP pin 5
RMD pins 2&4 to RDDP pin 7

Damn, I was close! Thanks for the info! I might have just come across one of those fuse holders, so my problems might be solved, but it great to have a backup plan

Looks like no more pics needed here!?!