Page 1 of 1
Need a RCA splitter, any inputs?
Posted: Mon May 24, 2010 6:39 am
by str3atwarrior
Hey it's me again!
Now that i'm changing the kenwood amp for a ZX475Ti, i'm in need of a RCA splitter. My deck gives me only 1 rca out for subwoofer. With the kenwood, i used one of theses :
http://thesiliconhorizon.com/store/imag ... M3inch.jpg
But with the ZX475Ti, i'm gonna need to split the signal into 4 channels, and i don't really feel like using 3 of them, too much signal lost. Can someone suggest me a good one?
Thanks!
Posted: Mon May 24, 2010 7:18 am
by AAMP217
You have 3 subwoofer amps? If the amps do not have an aux output then that is our only option that is cost effective. Signal loss shouldn't be an issue if you are splitting them in the rear.
Posted: Mon May 24, 2010 7:41 am
by str3atwarrior
I'm removing the kenwood amp to replace it with a ZX475Ti, which will be used to power up 2 xs124. I will use bridge mode on the amp, so i need to hook my sub out on my deck to both front and rear in of the amp, unless i'm missing something. Since my deck is providing only 1 RCA out, i need to split it into 4 RCA so i can hook all channels on the amp.
Posted: Mon May 24, 2010 7:50 am
by AVICJR
I believe that the ZX475Ti has a function setting allowing operation with only one set of RCA's in, which would eliminate having to add another splitter. Someone with this amp or more knowledge should be able to clarify this though.
Go to the manuals section of the forum and print it out if you haven't already.
Posted: Mon May 24, 2010 7:52 am
by str3atwarrior
Damn, you're right!
I've read this manual dozens of times since i've got the deal for the amp, but just never realised that the schema with 2 sub show only 1 rca with input selector to front!
Thanks again and sorry for the mistake
Posted: Mon May 24, 2010 8:24 am
by Bfowler
even though you dont need it this time....this is a good spot to know for cables:
http://www.knukonceptz.com/productDetai ... D=KRY-1F2M
