Phoenix Gold Phorum

im sure this was on the forum but cant seem to find it?

the ti finish is sanded sheet steel thats clearcoated ?

who has done the finish and got it close?

i have a belt linisher 4 inch wide i need to do some small parts to match the install do you think thats possible

so whats the best grit that gets close to the original finish?

thanks in advance

mike

I have only got a reactor to look like new never tried a ti

i would say (and minding the fact that i havent tried or done it yet)- BUT iyam, i would say a 220G, and just let her rip - all in same direction... then clear.

right il give it ago on some scrap and post up the results!!