pg ti 500.4
focal utopia audiom 6w
vibe 1500w sub cbr enclosure
Hey
Im currently running the focals on the front channel.
I want to install this sub using the pg amp.
1. Do i need to insert the bass rca's from the headunit into the rear channel of the amp, if so what frequency should i set the rear too 0-800khz. or can i just run the sub using the front rca's.
2. What configuration should i set the amp to :
s1. Use front and rear inputs, LPL controls lowpass auxiliary output
s2. Use front inputs only, LPL controls rear lowpass output
s3. Use front inputs only, LPL controls lowpass auxiliary output
s4. Use rear inputs only, LPL controls front and rear lowpass output
3. I bridge the sub on the rear channel is this correct?
Many thanks
pg ti 500.4
-
- Posts: 918
- Joined: Mon Dec 18, 2006 9:41 pm
- Location: Boise, ID
Did this too but with a ZX450 into a Boston Pro front stage and paralleled Infinity subs (2 ohm load) and it worked very well.Audiophiliac wrote:1. One set of RCAs into front is fine.
2. Set to S2.
3. Yes. Bridge it.
I ran a 500.4 like this for a while and loved it. Nice amp. The LPL is nice to have as well.
A mighty amp!
[b]Source: Clarion HX-D2 & changer
Mass storage and GPS: Sony Ericsson X1i
Amps: PG ZX475Ti, 500.4, 600.2
Cable: Monster XLN Pro
Drivers: Morel MT23, CDM88, Elate 6, 2 x Infinity Perfect 10VQ[/b]
[i]Australian MEASQ Judge[/i]
Mass storage and GPS: Sony Ericsson X1i
Amps: PG ZX475Ti, 500.4, 600.2
Cable: Monster XLN Pro
Drivers: Morel MT23, CDM88, Elate 6, 2 x Infinity Perfect 10VQ[/b]
[i]Australian MEASQ Judge[/i]
- 12voltjunky
- Posts: 565
- Joined: Tue Dec 15, 2009 5:10 pm
- Location: Atlanta, GA
the ti 500.4 is a wonderful amp you should never be dissapointed in it unless you find out the hard way, as i did, that it has no onboard fuses.
- hence my "deep fried" darling.
- hence my "deep fried" darling.
1- Zx 400 Ti
1- Ti 600.2
1- Ti 500.4 (resurrected by valeks1)
2- Ti 500.4
2- Ti 1000.2
2-Ti RMD, Lpl, PG 1/0 Ga
Ti 6.5 comps, Ti 5x7 coaxials
1- Ti 600.2
1- Ti 500.4 (resurrected by valeks1)
2- Ti 500.4
2- Ti 1000.2
2-Ti RMD, Lpl, PG 1/0 Ga
Ti 6.5 comps, Ti 5x7 coaxials