Phoenix Gold Phorum

where can I get these 2 controllers for my zx450 and what is it for, sorry I'm dumb. Oooh and this is what I have..... pix.

only one is a bass control. the other is a voltage display. the bass controller is lpl44 here http://www.amazon.com/Phoenix-Gold-LPL4 ... B002Q2QAJU

lpl is nothing more then remote volume adjustment for your sub. I am about to make one for myself and have the parts to make a 2nd of you want one.

The rddp output has a couple of options. There is a r-link that plugs into it and then give a couple of options or if you just get a car5 cable and the schematic in the fact section you can wire it up with out the rlink.

since the R500.1 came with bass control I guess I dont need the LPL control for it. I'll use the zx450 for mid only.

ttocs wrote:lpl is nothing more then remote volume adjustment for your sub. I am about to make one for myself and have the parts to make a 2nd of you want one.

The rddp output has a couple of options. There is a r-link that plugs into it and then give a couple of options or if you just get a car5 cable and the schematic in the fact section you can wire it up with out the rlink.

Thanks for the offered, I thought LPL is a must have item for the amp to run right but like you said it's just a remote so I don't think i needed it.

THanks

the lpl is a "low pass level" controller


so it wont affect anything unless you are using the LP crossover on your zx450, which it sounds like you aren't.