Hi all. I just bought an MS-2125 online and am trying to bridge 2 15" subs @ 2ohms to it and it doesnt sound good at all. I have an extra battery and will be adding a 6farad capacitor so I know power is not the issue. Am I doing something wrong or does the amp need to be set up a different way to be able to run that kind of load. Thanks.
-Dean
a cap won't do anything, the amp should be ok at 2ohms mono and pg stated it would do 720 wrms with this load. just pay attention to cooling
Ti1 headunit (unique)
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!
TA should be the same, should be good for 2 ohms mono with care.
Ti1 headunit (unique)
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!
regardless if the amp is TA or not i would be concerned about the amps health if that amp has sustained prolonged abuse its not going to perform well. suppose someone ran it 1 ohm bridged for any length of time the amp would have been very hot and stressed out the components. heat stress over time deminishes the amps components mostly the capacitors suffer and when they start going bad its a downward spiral from there.
you can run it at 2 ohms no problem just make sure that u have solid connections, should make sure u have some amperage though that thing will pull about 90amps at full tilt, i tested it before at 2 ohms on two 15s
with a vat 40.
most important though is to keep it cool so i would get some 9 inch crossflow fans and then let it blow.
You may have subs in your car........but my doors sound better!
Thanks everyone. I got it running at 2ohms. It turned out that I had a bad RCA cable that was cutting off the right channel. Where would I get the 9inch crossflow fans? Thanks again.
-Dean
