Phoenix Gold Phorum

Hey guys;

Looking to run 2x Ti12d Elites off an ARC AUDIO 4000SE with them setup in this sort of fashion:



Just wondering:

- What's the best sized enclosure for these in an SQ setup? - I've read the literature, but just seeing what people have found best since that has been release years ago.

- Will the Ti12d's love 2kW+ into each of them?

Cheers,

Chris

I have no answer but damn! I like the setup above, haha.

gonna need more space than what those quarters are offering... think it is something like 2.5 CSI not sure - have to check the specs in the manual on line.. but i know they will require chunks of air that dont look to be present in current set up/install

minimum 6 cubes for 2 of those subs. not gonna work in those kind of enclosures. IMO

Sure it'll work.......

Though.................

They'll only be 12" between them..............

Or be like so many others and face them into the car with a plexi window to show the goods and drop the amps to the sides.......

they will love that much power. you have to remeber how deep these subs are and they do need some real air space

Rold Gold wrote:Sure it'll work.......

Though.................

They'll only be 12" between them..............

Or be like so many others and face them into the car with a plexi window to show the goods and drop the amps to the sides.......

thats exactly what I thought when I read it.

Are you going sealed or ported? For sealed 1.4 cu. ft. ^2 each is what was recommended to me. 2K watts each would be KILLER!!!

http://download.phoenixphorum.com/Manua ... ev8.02.pdf

2.75 ported would be a winner.

tune them at about 31 and hold the f### on!

One of the nicest sounding setups I have heard used two Tantrum 1200.1's to a single Elite 12D. They were turned down to 2000w for music, and my god those Elites loved every drop of that power! That was in a 1.4 sealed box too! With two of them on 4kw I don't think you will need to worry about going ported (unless of course you are competing in SPL).

stipud wrote:One of the nicest sounding setups I have heard used two Tantrum 1200.1's to a single Elite 12D. They were turned down to 2000w for music, and my god those Elites loved every drop of that power! That was in a 1.4 sealed box too! With two of them on 4kw I don't think you will need to worry about going ported (unless of course you are competing in SPL).

Or.....if you just want to be louder than most.....

Thanks for the input guys!

Very keen to start getting some plans drawn up for this but yeah, I knew space would be a huge issue

ARC 4000SE just turned up after LOTS of BS with Customs

Birthsheer: 4606W @ 1Ω

I sure hope you have a big alternator and a couple of extra battery's. Haven't seen one before but they are very badass from what I've read.

280A Custom Alt is being installed and there will be 2x D34 Yellow Tops installed.

Power/GND will all be 00AWG; 2 runs for PWR to the 4000SE.

This is my sealed to spec box. PG manual says 1.8cu.ft. minus .2 sub volume and that brings you to 1.6cu.ft. for musical/sq spec. You're gonna love them

It will be crazy loud but I really like the old install more
great work on the sub box

I just posted a pic of my box as a comparison to having barely any extra room in the trunk running 2 elites.