Page 1 of 1
wire guage to feed BASSCUBE?
Posted: Sat Sep 11, 2010 4:41 am
by Blad09
What size wire is everyone using to power the basscube. I've got 16ga. right now with a 3 amp fuse... is that sufficient?
Posted: Sat Sep 11, 2010 4:45 am
by todd217
yes, 16awg big is enough.
Posted: Sat Sep 11, 2010 6:07 am
by opimax
Probably much more than enough! I am using very thin single stand power style wire , easy to route, takes minimal space. I have felt the cable for heat build up and have not noticed any...Have you read both manuals? there is no specs on this in either manual
Mark
Posted: Sat Sep 11, 2010 6:55 am
by ttocs
they are not current dependant pieces. As long as they are properly fused you have nothig to worry about. Sounds like you are fine.
Posted: Sat Sep 11, 2010 7:21 am
by The Golden One
actually phoenix gold recommends using 16 gauge wire for all of their signal processors so yes your right on target, but i wouldnt go any smaller than what is recommended.
Posted: Sat Sep 11, 2010 7:31 am
by Blad09
Great thanks alot all. Yea I couldn't find anything in the manuals or secrets so thanks again