one of my ti 600.2 amps is acting up. it plays normal but the leds dont turn on at all. anyone know how to fix or work on these amps?
3x ti600.2, 1x ti1000.2 (hidding in the closet),1x 6.5 ti elite comp (front), 1x 5.25 ti elite comp (back), 2x XO crossovers, 2x tantrumX dual 4 ohm, zero point full power+ ground wiring
6x pc-ccc zero point rca
storage for the rest of my stuff
but what would cause all 3 of them to stop working
3x ti600.2, 1x ti1000.2 (hidding in the closet),1x 6.5 ti elite comp (front), 1x 5.25 ti elite comp (back), 2x XO crossovers, 2x tantrumX dual 4 ohm, zero point full power+ ground wiring
6x pc-ccc zero point rca
storage for the rest of my stuff
maybe if their all three in the same circuit and one of them is bad then none of them will work it's all just rocket science but if that's not the case then maybe a bad resistor in the circuit.
it was like that in mine. One was crushed and took the other out with it. I would replace all 3 at once anyway but but it could possibly be the output to the leds....
what else can I say I am a grumpy asshole most of the time.