Phoenix Gold Phorum

Got me a pair of dual 4ohm voice coil subs that Im gonna bridge my X200.4 to.

Would 2 or 8 ohm mono be best on the 200.4?

You would think that that 8ohm mono would be better. I know the Xenon is rated 1-8 ohm stereo but I noted that on the ratings for the mono amps they are only rated 1-4ohm.

Also second question.

My signal path is going to be:

HU to my EQ30, EQ30 to my X200.2 then the output of my X200.2 to my X200.4.

I have a BassCube to put in there somewhere. At first I thought about putting it between my 200.2 and 200.4 then I got to thinking ....... would there be some benefit to putting it right after or just before my EQ30 so it effects the signal going to both amps??

The Xenon amps when bridged are 2-8 ohm so either way you wire it is good.

Wire your BQ where you want but I would wire it prior to the EQ so all items see the adjustment equally instead of creating a peak from the subs that would make them directional if the mids didn't receive the emphasized harmonics to blend it better.