Page 1 of 1
PG in a Hybrid Camry?
Posted: Thu Dec 23, 2010 9:19 am
by csperl1
Hey everyone,
I just uninstalled a system in my buddy's car and he purchased an 08 Camry Hybrid. I have never done an install in a Hybrid and was wondering if I can install a 2125 and zx450 in one? Electrical system differences? Etc?
Thanks in advance.
Re: PG in a Hybrid Camry?
Posted: Thu Dec 23, 2010 12:58 pm
by wash with gasoline
I dont know much about hybrids, but i know enuff to be VERY careful of the factory wiring.
They have some serious high amp, high voltage stuff going on that can kill you dead...
Re: PG in a Hybrid Camry?
Posted: Thu Dec 23, 2010 2:30 pm
by ttocs
not sure I would go with something so power hungry, as well as enefficient. Those are both class A's right?
Re: PG in a Hybrid Camry?
Posted: Thu Dec 23, 2010 2:50 pm
by csperl1
Thanks for the replies.
I think AB but they should suck a decent amount of current. I would most likely just use the 450 only with the front on a component set and rear on a small sub. I found this link which is giving me mixed answers.
http://www.greenhybrid.com/discuss/f51/ ... all-19146/