Do you HAVE to use 12 gauge speaker wire on the x600.1?
Posted: Sun May 13, 2007 10:27 am
Phoenix Gold Phorum
Celebrating the Phoenix Gold legacy, and oldschool car audio!
https://www.phoenixphorum.com/
Do you HAVE to use 12 gauge speaker wire on the x600.1?
Page 1 of 1
Posted: Sun May 13, 2007 10:40 am
I suppose that probably all depends on how far you have to carry the signal, kinda like power wire for your amp???
Posted: Sun May 13, 2007 11:23 am
You don't have to since the current is pretty minimal, but it doesn't hurt to use a heavy gauge.
Posted: Sun May 13, 2007 12:35 pm
Ok thanks, I have a high count 16 gauge blue/white twisted cable that I wanted to use. Its only about 2 feet max from the amp.
Also, on a DVC do you need to wire the sub in parallell outside the the amp, or does the xenon do that internally
Also, on a DVC do you need to wire the sub in parallell outside the the amp, or does the xenon do that internally
Posted: Sun May 13, 2007 1:09 pm
The terminals are already wired in a parallel fashion so if you run each coil back to the amp it is already running in parallel.
Posted: Sun May 13, 2007 1:09 pm
You can either run it from the amp (1 run of wire to EACH VC) or (1 run to one of the VC, and from that VC run a small + and - run to the other VC).Capital_M wrote:Also, on a DVC do you need to wire the sub in parallell outside the the amp, or does the xenon do that internally
Posted: Sun May 13, 2007 1:18 pm
alright thanks guys