semi broken amp?
Posted: Fri May 06, 2011 9:58 am
i have a xenon 100.2 that powers up, and plays music, its just very distorted. what did i break in it? usually when i break stuff i go for it all
Phoenix Gold Phorum
Celebrating the Phoenix Gold legacy, and oldschool car audio!
https://www.phoenixphorum.com/
semi broken amp?
Page 1 of 1
Re: semi broken amp?
Posted: Fri May 06, 2011 11:11 am
Xenon amps have surface mount technology. Far inferior than thru-hole and provide distortion, remember?
Re: semi broken amp?
Posted: Fri May 06, 2011 1:27 pm
dwnrodeo wrote:Xenon amps have surface mount technology. Far inferior than thru-hole and provide distortion, remember?
lol, that is true. i may have been abusing this amp quite a bit though.
Re: semi broken amp?
Posted: Fri May 06, 2011 1:55 pm
I heard that one time also so it must be true....
Re: semi broken amp?
Posted: Fri May 06, 2011 5:30 pm
use a magnet and see if they used a cast iron heatsink- could be iron oxide in the circuit
Re: semi broken amp?
Posted: Sun May 08, 2011 7:21 am
You're an idiot! Everyone knows only Rockford used cast iron heatsinks. PG uses cast gold...davewaibel wrote:use a magnet and see if they used a cast iron heatsink- could be iron oxide in the circuit
Re: semi broken amp?
Posted: Sun May 08, 2011 8:16 am
oh no....don't have him come back under another name,lol.... please!Eric D wrote:You're an idiot! Everyone knows only Rockford used cast iron heatsinks. PG uses cast gold...davewaibel wrote:use a magnet and see if they used a cast iron heatsink- could be iron oxide in the circuit