Page 1 of 1
help from the pros!!
Posted: Sun Jun 26, 2011 7:47 am
by mrduramax
can i plug this volt guage in my distribution bloc some way ?
how do the caps look in my new MS-275 ?
Thanks for the help guys
Re: help from the pros!!
Posted: Sun Jun 26, 2011 10:49 am
by ttocs
the meter should plug right into that spot on the dist block..
Re: help from the pros!!
Posted: Sun Jun 26, 2011 11:16 am
by mrduramax
the plug on the meter wire is smaler then the block female
Re: help from the pros!!
Posted: Sun Jun 26, 2011 11:19 am
by mrduramax
here tou go
Re: help from the pros!!
Posted: Sun Jun 26, 2011 1:02 pm
by dvnt88
mrduramax wrote:here tou go
The connection on the block is for an RDDP, some blocks allow you to connect an RMD, but from the looks of your cable connection on the block you will need an RDDP / SDT kit.
Re: help from the pros!!
Posted: Sun Jun 26, 2011 2:29 pm
by joerg
dvnt88 wrote:mrduramax wrote:here tou go
The connection on the block is for an RDDP, some blocks allow you to connect an RMD, but from the looks of your cable connection on the block you will need an RDDP / SDT kit.
Just to chime in here! The connection on the fused distro is for a unit named ZRDT3 and
not the RDDP/SDT kit.
The best way to use the RMD display u have is to cut off one of the plugs. When taking off the grey inulation of the cable u will find a green, a black a red and a yellow wire. Connect the red and yellow wire to +12Volts and the black and green wire to ground. You will see it´s going to do it´s job just fine!
Just make sure u take a switched +12Volts source for the red and yellow wire. If not doing so the RMD will be on all day long.
Re: help from the pros!!
Posted: Sun Jun 26, 2011 4:37 pm
by mrduramax
I think i need a diagram (i no i am slow)
Re: help from the pros!!
Posted: Mon Jun 27, 2011 6:28 am
by stipud
Re: help from the pros!!
Posted: Mon Jun 27, 2011 6:41 am
by mrduramax
thanks stipud
how do the caps look in my new MS-275 ?
Re: help from the pros!!
Posted: Mon Jun 27, 2011 8:47 am
by stipud
mrduramax wrote:thanks stipud
how do the caps look in my new MS-275 ?
If they are original, they need to be replaced, regardless of how they look. They leak out the bottom so it's usually hard to see. Sometimes you can test by sliding a piece of paper underneath them to see if you get any electrolyte on it.
Re: help from the pros!!
Posted: Wed Jul 06, 2011 11:19 am
by mrduramax
OK i plug it in and i get a( LO. )
Re: help from the pros!!
Posted: Wed Jul 06, 2011 1:45 pm
by stipud
Not sure what you mean, but if the caps are original I suggest not plugging it in, or they could fry on the spot.
