Phoenix Gold Phorum

Posted: **Wed Aug 10, 2011 9:59 am**

Hello all,

I had a custom box built, using a jl 13tw for space issues (crew cab truck). The 800.1 will fit back there, but it is tight. This is my first build, wouldn't mind knowing if the 600 bridged would be a better application as seems a couple inches smaller. I don't have any experience here, certainly non with this sub...would like to do it right the first time too. Thanks for any all advice.

Posted: **Wed Aug 10, 2011 12:30 pm**

What impedance is the jl?

Posted: **Wed Aug 10, 2011 12:31 pm**

It is 3 ohm

Posted: **Wed Aug 10, 2011 12:39 pm**

it will not take a buttload of power to get that 13 rockin a small cab like a truck. I have a single 10 in mine running off a octane LE and it fills it nicely. Swappin amps isn't that hard to do once the wire is ran so you can always swap it if ya want too.

Posted: **Wed Aug 10, 2011 1:29 pm**

i would just run the 600.2 then.

Posted: **Wed Aug 10, 2011 2:22 pm**

800.1 FTW

Phoenix Gold Phorum

800.1 vs. 600.2 and sub

800.1 vs. 600.2 and sub

Re: 800.1 vs. 600.2 and sub

Re: 800.1 vs. 600.2 and sub

Re: 800.1 vs. 600.2 and sub

Re: 800.1 vs. 600.2 and sub

Re: 800.1 vs. 600.2 and sub