Phoenix Gold Phorum

do you need a stereo signal to get full output on these amps or can you feed a mono signal in and get a full output?

you'll need both.

damn was hopin it would be easier. I decided to go ahead and solve the stereo/power problem I have had about powering my Ti9s with a 600.1 by getting a 2nd 600.1. So now each 9 will have its own amp and the three rsdc10s will be powered off of the 1200.1. STarting to think the basecube will really be overkill but I love the ability to tune it a little further...

I'm assuming the 9's are 4ohm? then the 600.1's are only going to put out 300 rms if you run them at 4ohms,
Is this what you are after? I would run them both off of 1-600.1 at 2 ohm's to get the 600 rms from it.
Are you not going to use your roadster in your install now? The RSd's are decent amps and do rated power easily if not more for sure, and I like them for the price it's just too bad that they suffer in the looks dept. IMO

300 is plenty for the 9s, I am more concerned about having them play stereo then I am puttin a few more watts to them.

Stryker wrote:I'm assuming the 9's are 4ohm? then the 600.1's are only going to put out 300 rms if you run them at 4ohms,

400@4ohms cea rated

like I said should be plenty of power, just about perfect really... Just need to shine up my shoe-horn to fit another 600.1 in now but the price was right.