roadster 66 do 1 ohm??
Posted: Tue Oct 04, 2011 9:44 pm
can it?
should I do it?
should I do it?
for the 4channel side for the manualbassman wrote:can it?
should I do it?
FOR STEREO MODE
Note: We recommend that the total speaker load is no less than 2 ohms per
channel
BRIDGED/MONO OPERATION
Note: For bridged/mono operation, we recommend that the minimum total
speaker load is no less than 4 ohms. (when two channels are bridged, each
channel will see half of the total speaker load)
and the 600.1 side
We recommend that the minimum total impedance of the speaker load is no
less than 2 ohm.
so no and no