Hey all,
Been sometime since i've been here, but glad to see I sitll have my account. I still have all of my pg stuff, but i'm a little rusty on a few of the settings on the EQ.
Is it ideal to use my 2125 and 2500 with just the eq215x to power my idq 6.5 midbass drivers and horns. No subs at this point will be installed.
If so how would you guys set the 215x for optimal sound.
Thanks,
Kevin
eq215x settings
eq215x settings
Head Unit: Eclipse CD5000
Amp1: Ti 500.4
Amp2: MPS2500
Crossover: Audiocontrol 6xs
High/Mids: ID CD1-E v1 Horns
Midbass: IDQ 6.5 v2
Subs: IDQ 12 v1
EQ: PG EQ215-X
Amp1: Ti 500.4
Amp2: MPS2500
Crossover: Audiocontrol 6xs
High/Mids: ID CD1-E v1 Horns
Midbass: IDQ 6.5 v2
Subs: IDQ 12 v1
EQ: PG EQ215-X
Re: eq215x settings
by ear or use an rta.
Re: eq215x settings
Thanks Todd.
Usually do it by ear so it takes quite a while. I guess that i'll need to see what the x-over freq are in the 215 to see if my midbass drivers can accomodate or not. If it's 50-250 or somewhere in between then i'm good. Not sure about going full range on the midbass though.
thanks,
kevin
Usually do it by ear so it takes quite a while. I guess that i'll need to see what the x-over freq are in the 215 to see if my midbass drivers can accomodate or not. If it's 50-250 or somewhere in between then i'm good. Not sure about going full range on the midbass though.
thanks,
kevin
Head Unit: Eclipse CD5000
Amp1: Ti 500.4
Amp2: MPS2500
Crossover: Audiocontrol 6xs
High/Mids: ID CD1-E v1 Horns
Midbass: IDQ 6.5 v2
Subs: IDQ 12 v1
EQ: PG EQ215-X
Amp1: Ti 500.4
Amp2: MPS2500
Crossover: Audiocontrol 6xs
High/Mids: ID CD1-E v1 Horns
Midbass: IDQ 6.5 v2
Subs: IDQ 12 v1
EQ: PG EQ215-X