Page 1 of 1
zpa problem!!!!!!!!!!!!
Posted: Wed Jun 06, 2007 9:19 am
by gixerboy
why does my zpa0.5 keep blowing fuses
happens seconds after turning the amp on.
blown 80amp fuses in distro block and once left them intact but blew 150amp under the bonnet???
please help
Posted: Wed Jun 06, 2007 9:30 am
by stipud
I assume you have not yet done the 2 ohm modification?
If not, that is certainly weird. Possibly a shorted output or something like that?
Posted: Wed Jun 06, 2007 9:44 am
by Bfowler
is i hooked up to anything yet? disconnect any leads from the outputs. if you already have....you might be PM'ing 1moreamp soon...
Posted: Wed Jun 06, 2007 9:50 am
by 1moreamp
One of mine drew excess current when I got it and it was slow draw like your describing. It was out of alignment and the channel bias was in run-away causing it to draw more and more current until it pegged my bench power supply.
Now this does not mean there is not something serious wrong with it , there might be, but by your description this is what it seems like. Have you been tinkering around the two little orange adjustments located in each channel ??? The one on the vertical card is the DC offset, the one on the main board is the output bias drive adjustment... nether should be touched unless you know what they are and how to adjust them
Posted: Wed Jun 06, 2007 9:52 am
by gixerboy
it did run the sub but turned it off and back on and it just started blowing fuses
im lost
i want some bass in my van as i cant live without it
very tempted to smash fuck out off it
Posted: Wed Jun 06, 2007 10:26 am
by mr tibbs
gixerboy wrote:
very tempted to smash fuck out off it
LMFAO!!! I have been there soooooo many times mang!! Keep your head up, it'll get better!!
Posted: Wed Jun 06, 2007 10:31 am
by 1moreamp
gixerboy wrote:
it did run the sub but turned it off and back on and it just started blowing fuses
im lost
i want some bass in my van as i cant live without it
very tempted to smash fuck out off it
OK it sound like something went south on you and the amp shutdown to protect, and now on power up it blows fuses STOP turning it on, it has issues and needs to be benched ASAP. If you keep replacing the fuses you will just cause more damage... It sounds like it has shorted devices inside it and they will only get worse if you keep trying. PM me and I will give you my number to reach me if your interested C
Posted: Wed Jun 06, 2007 10:35 am
by Mastiff
gixerboy wrote:
it did run the sub but turned it off and back on and it just started blowing fuses
im lost
i want some bass in my van as i cant live without it
very tempted to smash fuck out off it
ok box it up sell it to me and your problems are solved ! how much ?
Posted: Thu Jun 07, 2007 12:03 am
by Mastiff
well still pissed?