Page 1 of 1
475ti to run Dynaudio MW160?
Posted: Sat Nov 19, 2011 5:23 pm
by ShockTherapy
Hi all! Haven't checked in in a while, hope everyone is doing good. As you can see from my sig I've switched a few things up.
Just curious if anyone has bridged the 475 on midbass? I felt my Dyns were terribly underpowered at 100x2 and wanted to open them up. I picked up a 475ti on DIY and am planning on bridging it (250x2) to the Dyns... any thoughts? I won't get the amp til Friday and am wondering what to expect. I'll be using an MS8 for all processing.
Re: 475ti to run Dynaudio MW160?
Posted: Sat Nov 19, 2011 7:46 pm
by 00goobs
I just got some TI9s and was planning to bridge a TI500.4 to do the same thing. I'll try them on a ZX600ti first. If it isn't enough, then I'll bridge the 500.4...
Re: 475ti to run Dynaudio MW160?
Posted: Sun Nov 20, 2011 12:58 am
by ShockTherapy
The 600 is a beast! But the 500.4 should give you an extra 100w/ch. I'm thinking that the 500.4 might open them babies up. I'm really looking forward to feeding my Dyns some power!... 100w/ch isn't enough in my opinion. Still curious if any of our members have tried using the ZX475ti in this configuration.
Re: 475ti to run Dynaudio MW160?
Posted: Sat Dec 24, 2011 10:42 pm
by NRA4ever
I used my 475 bridged on a set of Exodus audio Anarchy 6.5s. It woke them up. They get loud with it.
Re: 475ti to run Dynaudio MW160?
Posted: Sun Dec 25, 2011 8:37 am
by tonym
ShockTherapy wrote:The 600 is a beast! But the 500.4 should give you an extra 100w/ch. I'm thinking that the 500.4 might open them babies up. I'm really looking forward to feeding my Dyns some power!... 100w/ch isn't enough in my opinion. Still curious if any of our members have tried using the ZX475ti in this configuration.
how did it work out brideged? my AVI's love power also but only have an m50 on them
Re: 475ti to run Dynaudio MW160?
Posted: Sun Dec 25, 2011 5:33 pm
by Damo95
I'm using a bridged tantrum 600.4 for my morel elate 6 midbass, and they love the power..