Phoenix Gold Phorum

I'm adding a sub to my 08 Maxima SE and need to know the color diagram for base model (without Bose). I plan on tapping into the rear speakers behind factory HU to a PG SLD44 LOC to add a amp and sub.

Thanks!

honestly it really will not matter. Look at the hrns and make note of the wires and which whay they are in the clip/hrns. Connect the + to the same side and the - on the same side of both hrns's and you will be fine.

ttocs wrote:honestly it really will not matter. Look at the hrns and make note of the wires and which whay they are in the clip/hrns. Connect the + to the same side and the - on the same side of both hrns's and you will be fine.

Thanks Scott!! So, there's 2 harnesses for the front and rear?! I haven't opened it up yet so I really don't know, that's why I'm asking.

two hrns's, left and right. I thought you were connecting in the rear it said? Like I said just be sure to wire them into the loc the same way and you will be fine.

ttocs wrote:two hrns's, left and right. I thought you were connecting in the rear it said? Like I said just be sure to wire them into the loc the same way and you will be fine.

Thanks again! Yes, I plan on tapping into the rear unless you have an alternate (better) suggestion? I want to tap into it before the amp and as close to the HU as possible.

yea I always recomend tapping the signal behind the deck honestly or you run a really good chance of noise. If you want to do that, take note of the wires at the back by the hrns and write down their colors and what you want to hook them up too(pos or neg). Now just take that info to the back of the deck and find those wires there.